EAM hardware information EEPROM

${loadingIndicator}

Setting/field Saved (EEPROM) setting Active setting
Serial number
NB: this is only used for display purposes, and it is possible that it does not match the label depending on the device's history. The label should be taken as authoritative in all cases. 		${savedSerial} ${activeSerial}
GPIO set/hardware type ${savedGPIOset} ${activeGPIOset}
Voltage sensor scale
Most hardware has 0.8333 scaling, some has 0.1667. 		${savedINA209Scale} ${activeINA209Scale}
Flash module size Allows the flash module status program to scan for and verify the flash module. This is internal NAND flash, not a USB flash drive. ${savedFlashModuleSize}MiB ${activeFlashModuleSize}MiB
Override eth0 speed
For remote units which are connected through runs of under-specified Ethernet cable, it may be dangerous to allow the user to configure the Ethernet media type, as they may inadvertantly set it to something non-functional. This setting will cause any user configuration to be ignored. 		${savedEth0Media} ${activeEth0Media}
Spyrus USB ${savedSpyrusUSBpresent}
${savedSpyrusUSBline}		 ${activeSpyrusUSBpresent}
${activeSpyrusUSBline}
EEPROM log
The dates here depend on the system clock being set at the time the entries were made and may be completely inaccurate. 
${savedManufLog}
 
${activeManufLog}

Actions

${saveActive}

${restoreActive}

 USB Spyrus card present Not present Settings are not present in Flash. Either restore them from EEPROM or enter new settings and save them. Settings are not present in EEPROM. Verify the active settings and then save them. There are differences between the Flash and the EEPROM settings. This is usually caused by the EEPROM not being programmed correctly during production. Verify which settings are correct and save or restore them. Save active settings to EEPROM Invalid setting Serial number is invalid. Must be 1–40 alphanumeric characters, underscore, dash, dot or plus. Scale for voltage sensor is invalid. Must be a floating-point number. Try 0.8333. Flash module size is invalid. Must be an integer from 0 to 65536 (64GiB). Failed to save settings ({1}). Check free flash space? Restore active settings from EEPROM Not present Unknown GPIO set ‘{1}’. Aluminium or steel tube (sXam) 3-port EAM-U 3-port Peli case Integrated instrument (e2am) CMG-3EX Rackmount EAM 7-port EAM-U 7-port Peli case EAM20 module (neptune) Borehole authenticator ASE-DCM-0026 ocean bottom system DM24S12EAM string sensor No override 100BASE-TX full duplex 100BASE-TX half duplex 10BASE-T full duplex (very unusual) 10BASE-T half duplex